How to install led light tube t8 t10 retrofit tubes

Step 1. Unpack the product:

• Unpack and carefully examine the product from top to bottom.
• Report any damage and save all packing materials, if any part was damaged during transport.
• Do not attempt to use this product, if it is damaged.

Step 2. Planning the installation:

• This device installation requires planning to ensure
• successful installation with minimal complications and down time.

Step 3. User responsibilities:

• It is the responsibility of the contractor, installer, purchaser,
• owner, and user to install, maintain, and operate the device in such a manner as to comply with
• all state and local laws, ordinances, and regulations.

Step 4. Product installation steps:

• Disconnect power to fixture at source. DO NOT SIMPLY SWITCH OFF FIXTURE
• Remove existing fluorescent tubes and safely set aside.
• Disconnect (cut) wires to ballast leaving enough wire to be tied off with wire nuts.
• Tie-off remaining wires attached to ballast with wire nuts.
• See wiring diagram shown on reverse for your type lamp fixture (i.e., 1-bulb, 2-bulb, 4-bulb and etc.) and re-wire fixture.
• Install Aladdin LED Retrofit Tube(s) into fixture.
• Affix included warning labels to fixtures near lamp connection/sockets of fixture so they are visible to bulb installers.
• Re-connect power supply and turn on switch. Tube will light.